Followers

Thursday, 17 December 2015

3D Floral Hanger

Good Morning Crafters
 
Today we have a beautiful 3d floral hanger from Pandy.
 
Products used by Pandy from the Personal Impressions website.
 
Check out the Stockist Locator on the home page for a stockist near you.
 
To create the 3d Floral Hanger you will need the following:
 
Marianne Design Pretty Papers Bloc – French
Spellbinders Nestabilities die set – Scalloped Squares
Scalloped Squares Memento inks pads – Rose Bud – Bamboo Leaves
 Sponge blender
Double sided tape
Cord / twine to hang
Embellishments to decorate the shapes
 
Step 1
 
Cut 6 of each of the 5 size squares and score across the centre from corner to corner.
 
Step 2
 
Ink all the edges with the Memento inks

Step 3
 
Crease the first shape well – put double sided tape on the outer edges – crease the next shape well – match up the edges of all the outer bumps and peel the backing off the double sided to secure.
 
Step 4
 
Match up all 6 pieces of each size in this way – but leave the last section open to fit the hanging string.
 
 
Step 5
 
Take 3 lengths of twine – plat about 6” - tie a loop at one end – add some beads onto each string and slide up to the loop.  Put a wide strip of double sided tape onto the inner spine of the shape – plat loosely enough twine to fill the length of the shape.

Step 6
 
Press the twine into the double sided tape – secure the shape sides together round the twine.
 
Step 7
 
Add a few more beads to the twine – plait a little more – attach the next shape.
 
 
Step 8
 
Continue using up the shapes – add a few beads or a tassel to the end of the twine.
 
You can take it a step further and decorate your hanging as much or little as you wish.
 
 
This looks fabulous and you could decorate with baby papers for a baby's nursery.
 
Thank you for visiting Today
 


No comments:

Post a Comment